Publicité
Les langues disponibles
Les langues disponibles
Starting at the docking station, follow the
edge of the mowing area clockwise with
the robotic mower. For this purpose, lift the
machine slightly by the rear carrying
handle (1) to relieve the weight on the
drive wheels. Push the robotic mower,
supported by its front wheels, and follow
the perimeter wire (2). It must be ensured
that the perimeter wire (2) runs under the
wire sensors. The wire sensors are
installed in a protected position on the left
and right at the front of the robotic mower.
During the wire break search, the signal
strength is indicated on the display; the
wire sensors are in the ideal position
above the perimeter wire when this value
is at its highest.
The Wire signal OK symbol
appears on the display when
the wire sensors are correctly
receiving the wire signal.
In the area of the wire break, the
signal strength drops and the
Check wire signal symbol
appears on the display.
150
● Bridge the break with the aid of a wire
connector (
12.15). If necessary, re-
route the perimeter wire in the area of
the break.
● Reconnect the left wire end. (
● Once the wire break has been correctly
rectified, the red LED illuminates.
(
13.1)
16.8 Storage and winter break
Note the following points when storing the
robotic mower (e.g. winter break,
temporary storage):
● Charge the battery (
15.7)
● Switch off automatic mowing (
● Activate the highest safety level
(
11.16)
● MI 422 PC:
Activate ECO energy mode (
● Activate the disabling device (
● Disconnect the power supply unit plug
from the mains
● Carefully clean all external parts of the
robotic mower and the docking station.
Cover the docking station with a suitable
bucket, fasten the bucket.
● Store the robotic mower on its wheels in
a dry, closed and dust-free room. Make
9.10)
sure that the machine is kept out of the
reach of children.
● Always store the robotic mower in good
operational condition.
● Keep all screws tightly fastened,
replace danger signs and warnings on
the machine that have become illegible,
check the entire machine for wear and
damage. Replace all worn or damaged
parts.
● Any machine faults must be completely
remedied prior to storage.
11.5)
Never place or store objects on the
robotic mower.
The temperature in the storage
room should not fall below 5°C.
11.11)
Resuming operation of the robotic
5.2)
mower following storage for a long period:
The date and time may need to be
corrected following storage for a
long period. Appropriate selection
windows are displayed during initial
operation. If the selection windows
are not automatically displayed,
check the date and time in the
"Settings" menu and correct if
necessary. (
● Prepare the mowing area:
Remove foreign objects and cut high
grass short using a conventional lawn
mower.
● Uncover the docking station and
connect the power supply unit to the
mains supply.
● Charge the battery (
11.11)
15.7)
0478 131 9935 C - EN
Publicité
