Publicité
Les langues disponibles
Les langues disponibles
Starting routing with an external
docking station:
Fasten the perimeter wire (1) to the ground
on the left or right as appropriate, behind
the floor plate, directly next to a wire outlet,
using a fixing pin (2).
Provide a free wire end (1) with a length of
approx. 2 m.
0478 131 9935 C - EN
Route the perimeter wire (2) in front of and
behind the docking station (1) with
clearance A and at right angles to the
floor plate. Then install a corridor.
(
12.10)
A freely travellable area with minimum
width B must be available to the side of
the floor plate.
A = 50 cm
B = 40 cm
Further information on installation
of the external docking station is
contained in the Installation
examples section. (
Wire routing in the mowing area:
Route the perimeter wire (1) around the
mowing area and around any obstacles
(
12.8) and fasten it to the ground using
fixing pins (2). Check the clearances using
the iRuler. (
27.)
Avoid routing at acute angles (less than
90°). In acutely angled lawn corners,
fasten the perimeter wire (1) to the ground
with fixing pins (2) as illustrated.
12.5)
111
Publicité
