RIDGID R4122 Manuel D'utilisation page 25

OPERATION
TO SUPPORT LONG WORKPIECES
See Figure 31.
Long workpieces need extra supports. Supports should be
placed along the workpiece so it does not sag. The support
should let the workpiece lay flat on the base of the saw and
miter table during the cutting operation. Use the work clamp
or C-clamp to secure the workpiece.
LONG
WORKPIECE
WORKPIECE
SUPPORTS
TO CLAMP WIDE WORKPIECES
See Figure 32.
When cutting wide workpieces, such as nominal
2 in. x 7- 1/2 in. boards, should be clamped with the work
clamp or C-clamp.
Fig. 31
25 - English
WIDE
BOARD
Fig. 32