RIDGID R4122 Manuel D'utilisation page 18

ASSEMBLY
SQUARING THE BLADE TO THE FENCE
See Figures 16 - 22.
 Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Lift the miter lock lever, then depress and hold the detent
release button to release the miter table.
 Rotate the miter table until the scale indicator is
positioned at 0° and the control arm is seated in the
positive notch.
 Release the detent release button, then push the miter
lock lever down to secure the miter table.
 Loosen bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
 Lay a square flat on the miter table. Place one leg of the
square against the fence. Slide the other leg of the square
against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 18.
 If the front or back edge of the saw blade angles away from
the square as shown in figures 19 and 20, adjustments
are needed.
 Remove the sliding miter fences from the fence. See
figure 16.
SLIDING
MITER
FENCE
FENCE
SCREW
SLIDING
MITER
FENCE
FENCE
DETENT
RELEASE
BUTTON Fig. 16
18 - English
 Turn the fence screws 2-3 times, counter clockwise, to
loosen and slide miter fences toward the saw arm until
they are flush with the miter table.
 Remove the sliding miter fences by pulling them up and
away from the miter table.
 Using the blade wrench, loosen the socket head screws
that secure the fence to the miter table. See figure 17.
 Rotate the fence left or right until the saw blade is parallel
with the square.
 Retighten the screws securely. Check blade squareness
to fence and readjust if necessary.
 Replace the sliding miter fences.
Your saw has several scale indicators. After squaring
adjustments have been made, it may be necessary to loosen
the indicator screws and reset them to zero. See Figures
21 - 22.
SOCKET
HEAD
SCREW
SLIDING
MITER
FENCE
MITER
TABLE
VIEW OF BLADE SQUARE WITH FENCE
FENCE
SOCKET
HEAD
SCREW
BLADE
MITER
SQUARE
LOCK LEVER
Fig. 17
Fig. 18