Carson Specter Mode D'emploi page 8

Servo Reverse
GB
These reverse switches
allow the rotation of the
servo(s) to be reversed.
The servo(s) rotate(s)
clockwise at NOR
position and rotate(s)
counterclockwise at
REV position.
Throttle trim
Move the trim tab to adjust the
throttle servo (or the speed
controller) at the
neutral position.
Charging Jack
Note: ON/OFF switch should
be at „OFF" position before
charging!
ATTENTION!
Never attempt to
charge non
rechargeable
batteries!
Charging jack
8 Specter 202001 · 202002 · 204003 · 204006
Servo-Reverse
(steering)
Servo-Reverse
(throttle)
Steering trim
Rotate the trim to adjust
the steering servo at the
neutral position. When
you adjust the position
of the steering servo,
set the steering rate
adjuster (ST.D/R)
at the maximum
position so that the
movement of the
steering rate adjuster
is maximized and therefore
it is easy to adjust.
Steering rate adjuster (ST.D/R)
Strokes of the steering
servo horn can be adjusted
by rotating this steering
rate adjuster (ST.D/R), in
the range from 10% to
100%.
The bigger the
percentage is, the
more sensitively
the steering servo
operates.
How to change transmitter batteries
• To remove the battery
cover, push both of the tabs
towards the centre, and
then pull the cover. Please
be careful that batteries
may pop out when the
cover is opened.
• If the transmitter
voltage indicator
fails to register,
check the con-
tacts, especially
the negative
(-) terminals and
recheck that bat-
teries are fitted
correctly.
• Also make sure the
batteries are fully charged.
-
+