Publicité
Les langues disponibles
Les langues disponibles
EN
COMMISSIONING
CONNECTION TO THE COMPRESSED AIR SYSTEM
- Compressed air enters the jack circuit through the quick coupling located on the jack`s manual raising and lowering
control; a connecting hose with a quick coupling compatible with that of the jack is therefore required. Check that the air
supply hose has a usable internal diameter of at least 6 mm, and is not kinked or blocked anywhere. DWG. 7
Working air pressure: 8 - 10 BAR.
- Never allow hydraulic fluid, petroleum jelly, brake fluid, petroleum or other liquids to enter the compressed air circuit.
-Install a drier-lubricator filter unit in the compressed air system.
- If you need to lubricate the compressed air circuit, use only:
AGIP OSO 100; MOBIL DTE 27; ESSO TERESSO 100;
SHELL TELLUS 100; BP ENERGOL HP 100
ACCESSORIES
- The machine may be supplied with two extensions or height adaptors (long extension 100 mm, short extension 50 mm).
Never use more than one extension at a time!
due to failure to observe the indications above, and the warranty shall also be forfeit if they are not
respected!
SCRAPPING AND DISPOSAL
- The user must follow applicable legislation when scrapping the jack and its component parts.
USE
- Follow the safety rules given in this manual to the letter.
The manufacturer shall not be liable for any breakage or damage to the lifted vehicle or other property, or personal
injury, due to incorrect use of the jack.
The rest position of the jack may not be at the minimum height. If necessary, bring the jack to its minimum height by
pushing the lever on the distributor to the left. DWG. 8
1. Position the jack beneath the support point indicated in the vehicle manufacturer`s manual.
2. Push the lever on the distributor valve to the right to raise the jack. DWG. 8
The manufacturer shall not be liable for any damage
13
Publicité
