Miele PW 6241 EL Schéma D'installation page 32

en - Technical data
Water connections
Cold water connection
Required flow pressure
Maximum flow rate (if no hot water and hard water supply)
Maximum flow rate
Threaded union required (male thread, to be provided by customer in accordance with
DIN 44991, flat sealing)
Length of water inlet hose supplied
*With liquid dispensing
Hot water connection
Maximum permissible hot water temperature
Required flow pressure
Maximum flow rate
Threaded union required (male thread, to be provided by customer in accordance with
DIN 44991, flat sealing)
Length of water inlet hose supplied
Hot water connection (for variants with reduced heater rating RH)
Hot water connection (for variants with reduced heater rating)
Required flow pressure
Maximum flow rate
Threaded union required (male thread, to be provided by customer in accordance with
DIN 44991, flat sealing)
Length of water inlet hose supplied
Hard water connection
Required flow pressure
Maximum flow rate
Threaded union required (male thread, to be provided by customer in accordance with
DIN 44991, flat sealing)
Length of water inlet hose supplied
Waste water (drain valve)
Maximum waste water temperature
Machine-side drain connection (external diameter)
On-site drain (internal diameter)
Maximum flow rate
A vented combined pipe is required to drain the waste water. If several machines are connected to a single drain pipe, this should be
sufficiently large to allow all machines to drain simultaneously.
Securing the machine
Fittings
4 x wood screws DIN 571 (Ø x length)
4 x plugs (Ø x length)
Fixing the machine in place is absolutely essential.
Fastenings for floating screed must be supplied by the customer on site.
32
100–1000 kPa (1–10 bar)
74 (79,5*) l/min
26 (31,5*) l/min
3/4"
2 (3*) x 1550 mm
60 °C
100–1000 kPa (1–10 bar)
16 l/min
3/4"
1 x 1550 mm
90 °C
100–1000 kPa (1–10 bar)
16 l/min
1 x 1550 mm
100–1000 kPa (1–10 bar)
32 l/min
3/4"
2 x 1550 mm
95 °C
HT DN 70
75 x 1,9 x 110 mm (Muffe DN 70)
200 l/min
12 mm x 90 mm
16 mm x 80 mm
1"