Miele PW 6241 EL Schéma D'installation page 25

BSK = Payment
system kit
safety mechanism in accordance with EN 61770 and EN 1717. The
maximum flow rate is 1500 ml/min with a maximum flow pressure of
300 kPa.
These connectors are sealed and need to be drilled open using a
8 mm drill bit before connecting.
Make sure that you only drill through the first panel (I) as there is a
deflecting panel (II) 10 mm behind it.
Connections 3 to 12 are provided for liquid detergent. High pressure
dispensing systems with water injection must not be connected to
these connections. The connectors are sealed and must be cut to the
diameter of the hose with a small saw before they are connected.
If opened connectors are no longer required, they must be resealed
using a suitable sealant (e.g. silicone).
Connection terminals for five time-controlled dispenser pumps, which
can be operated without a multifunction module, are located behind
the cover adjacent to the electrical connection.
Calibration of the dispenser pumps and regulation of dispensing
quantities is carried out partly automatically for washing machines
fitted with an optional multifunction module. Information regarding
settings is given in the operating instructions.
A flowmeter or flow sensors can also be connected for monitoring the
dispensing quantity precisely.
Connections for level monitoring are available for every agent
dispensed.
Optional accessories
Only use genuine Miele spare parts and accessories with this
machine.
Using spare parts or accessories from other manufacturers will
invalidate the warranty, and Miele cannot accept liability.
The washing machine can be equipped with a payment system (e.g.
for self-service operations) using the optional BSK payment system
kit. This must be connected and programmed by a Miele Service
technician. Payment systems with mechanical or electronic coin
validator are available from Miele as optional accessories for individual
target groups.
en - Installation notes
25