UFESA AP5150 Mode D'emploi page 18

CONNECTING THE TUBE AND ATTACHMENTS
• Press the button to extend the telescopic tube to desired length.
• Insert the flexible hose into the tube.
• Attach the vacuum cleaner brush to the telescopic tube.
- The floor brush is intended for cleaning flat floor surfaces or flooring.
- The crevice/furniture nozzle s intended for cleaning tight corners and gaps in furniture upholstery.
To clean curtains or vacuum the dust from the furniture, turn the attachment as indicated to the
brush position.
INSTRUCTIONS FOR USE
• Before using the appliance, unwind an adequate length of the power cord and connect the appliance
to the power mains.
• Press on/off button and start the appliance. Press the same button again to switch off the appliance.
• Airflow can be set using the regulator on the flexible hose:
- when cleaning curtains, dust from books, furniture etc., reduce the airflow;
- when cleaning flat floor, increase the airflow.
To retract the power cord, press the cord reel button. Hold and follow the power cord with you hand to
prevent a whip-like strike that could result in injury or damage.
Note: Do not turn the vacuum cleaner during operation to prevent water in the dust bin from entering the
motor unit, and to prevent water from spilling over the vacuum cleaner or the floor.
Dry vacuum cleaning
This appliance is used for vacuum cleaning the dust. If the water is very dirty, replace it with fresh water.
When an excessive amount of dirt is accumulated in the dust bin, further suction and therefore vacuum
cleaning will not be possible. Appliance operation will be slower and louder when you switch on the motor.
Note: Never use the vacuum cleaner without any water in the dust bin.
Filling the dust bin
Switch off the appliance using the main switch and pull out the power cord. These precautions provide
safety and prevent hazards related to the appliance. To remove the dust bin / water tank from the
appliance, hold the dust bin handle. Empty the water from the dust bin. See figure below.
TIP: After each use, empty the water from the dust bin to avoid unpleasant odour in the bin.