Worx WG711E Mode D'emploi page 9

-- After striking a foreign object. Inspect the
appliance for damage and make repairs as
necessary;
-- If the appliance starts to vibrate
abnormally (check immediately).
MaINTENaNCE aND STORaGE
1. Keep all nuts, bolts, and screws tight to
be sure the appliance is in safe working
condition.
2. Check the grass catcher frequently for wear
or deterioration.
3. Replace worn or damaged parts for safety.
4. Do not try to repair the machine or access
internal parts. Use authorised service
centres only.
5. Only use the replacement blade, blade
bolt, spacer and impeller specified for this
product.
6. Be careful during adjustment of the
lawnmower to prevent entrapment of the
fingers between moving blades and fixed
parts of the machine.
7. If an extension cord is used make sure it is
for outdoor use and marked as such. The
recommended size of extension cord is not
lighter than 1.0mm2 and a maximum of 10
meters in length.
8. All electric power tools should be properly
insulated and any extension cable should
be orange so it will stand out when laid
around the garden
9. When using a hand controlled electric tool,
feed the cable over your shoulder, this
should prevent you cutting through it.
aTTENTION: Through poor conditions
of the electrical MaINS, shortly voltage
drops can appear when starting
the EQuIPMENT. This can influence
other equipment (Eg. blinking of a
lamp). If the MaINS-IMPEDaNCE
Zmax=0.38+0.24JOHM, such
disturbances are not expected. (In case
of need, you may contact your local
supply authority for further information).
Lawn mower
All manuals and user guides at all-guides.com
SyMBOL DESCRIPTIOn
Warning
Read the user instruction carefully
and make sure you understand all
the controls and what they do.
Always keep the lawnmower on
the ground when mowing. Tilting
or lifting the lawnmower may
cause stones to be thrown out.
Keep bystanders away. Do not
mow whilst people especially
children or pets are in the mowing
area.
Beware of severing toes or hands.
Do not put hands or feet near a
rotating blade.
Switch off! Remove plug from
mains before adjusting, cleaning or
if cable is entangled or damaged.
Keep the cable away for the blade.
Blade continues to rotate after
the machine is switched off. Wait
until all machines components
have completely stopped before
touching them.
Do not mow in the rain or leave
the lawnmower outdoors while
raining.
9 9
En