Stryker MX-PRO R3 Mode D'emploi page 38

B
A
F F i i g g u u r r e e 2 2 5 5 – – B B a a s s e e l l u u b b r r i i c c a a t t i i o o n n l l o o c c a a t t i i o o n n s s
4. Apply T T r r i i - - F F l l o o w w ™ to the right and left height adjustment racks (C) (Figure 26). Provide an even application.
5. Apply T T r r i i - - F F l l o o w w ™ to the right and left slide plates (D) (Figure 26). Provide an even application.
F F i i g g u u r r e e 2 2 6 6 – – H H e e i i g g h h t t a a d d j j u u s s t t m m e e n n t t r r a a c c k k s s a a n n d d s s i i d d e e p p l l a a t t e e s s
6. Let the cot sit for five minutes.
7. Turn the cot back over. Raise and lower the cot a few times to work the lubricant throughout the applied areas.
8. Wipe any excess lubricant from the base tubes.
9. Verify proper operation before you return the cot to service.
EN 34 6082-209-005 Rev AA.2