tau K130MA Notice D'installation page 27

programming buttons.
It will be sufficient to have an already programmed transmitter in the receiver in order to start the
procedure of remote programming of the new transmitters. Follow the procedure written on the
instructions of the transmitter T-4RP / K-SLIM-RP / S-2RP / S-4RP (V 4.X).
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ Keep button CH1 pressed for 3 seconds in order to cancel all the associated radio control devices;
2_ LED DL2 flashes slowly to indicate that the cancellation mode has been activated;
3_ press button CH1 again for 3 seconds;
4_ LED DL2 turns off for approx. 3 seconds and then remains steady to indicate that the code has been
cancelled;
5_ repeat the procedure from point 1 using button CH2 to cancel all the associated radio control devices;
6_ repeat procedure from point 1 using CH1 and CH2 buttons at the same time to erase all transmitters
programmed into the third channel;
7_ to exit the learning mode without memorising a code, press button CH1 or CH2 briefly.
MEMORY CAPACITY
The code memory capacity* can be expanded from 30 to 126, 254 or 1022 codes (transmitters) by replac-
ing the memory cards as follows (plug them onto J3 connector, see wiring diagram):
126 codes
254 codes
1022 codes
* Control units are supplied with a standard built-in 30-code memory. The memory card for enhancing
the code memory capacity must be ordered separately.
To allow the previously stored codes (max. 30) to be moved to the control unit, it is required to install
a memory card, making sure that the control unit is at that time off and that the memory card is brand
new and therefore completely empty.
When the control unit is restarted, the codes will automatically move to the memory card.
Moving the codes from the control unit to the memory card does not work if on the memory card used,
radio control codes have already been stored and the memory card has been subsequently erased.
To insert new radio controls, the operation described above shall be repeated.
WARNING: Control unit must be turned OFF to insert / remove a memory card.
RADIO MEMORY RESET:
- keep the CH1 and PROG keys pressed until the green DL1 and orange DL2 leds start flashing rap-
idly. At this point, release the keys and press them again until the LEDs go off, confirming that the
operation is complete (if they are not pressed and you wait, the board returns to normal operation
after about 12 seconds).
HARD RESET (factory setting):
-
Keep the CH2 and PROG keys pressed until the green DL1 and the red DL2 LEDs start flashing
quickly. At this point, release the keys and press them again until the DL1, DL2 LEDs switch off.
Release the keys; all the LEDs will turn off confirming that the operation is complete. After about
5 seconds the DL2 will start flashing red/green.
If they are not pressed and you wait, the control unit returns to normal operation after 12 seconds.
Upon restarting, it will be necessary to carry out the memorization procedure.
In case of Hard Reset the memory of the radio receiver will not be erased: all existing
transmitters remain programmed.
11. SET-UP FOR OPERATION WITH TAU APPS
In order to use the TauApp and TauOpen apps, it will be necessary to connect to input J4 of the control
unit using the supplied cable, the respective T-WIFI and T-CONNECT devices. To activate the operation
of the apps see the respective instructions.
Art. 250SM126
250SM254
Art.
Art. 250SM1022
27