Pushing Aid; Preliminary Remark; Signs And Symbols; Important Safety Information - Bischoff & Bischoff Togo 8010 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TOGO

| pushing aid

1. Preliminary remark

Dear user:
You have chosen a top quality electric pushing aid from Bischoff &
Bischoff. We thank you for your trust in us.
The pushing aid follows the typically simple B+B use and operation
concept. The pushing aid can be folded for transport in a car. The
Togo pushing aid fits most current wheelchairs thanks to its universal
adapter plates.
All functions, such as on/off, forwards/reverse, speed regulation
and control, can be operated from the central operating unit on the
handlebar. A wheelchair equipped with the Togo pushing aid can
optionally be provided with active lighting, making it well-suited to
use outdoors.
Before operating for the first time, please read this manual carefully.
This manual is a permanent and necessary part of the Togo pushing
aid. Please keep the instruction manual within reach and place it at
the new user's disposal if the pushing aid is transferred to another user.
Repair work and adjustments require specific technical training and,
therefore, may only be carried out by specialist retailers authorised by
Bischoff & Bischoff.

1.1. Signs and symbols

22
Caution! Indicates information that is particularly
relevant to safety. Follow the instructions for use.
Important! Indicates information that is particularly
useful in the respective context.

2. Important safety information

2.1. General safety information

In order to avoid toppling and dangerous situations, you should
practice safe handling of your new wheelchair drive on a flat and
familiar surface. You will be shown how to use the pushing aid and
all functions by an authorised specialist retailer.
Mounting the bracket onto the standard wheelchair must be
undertaken by an authorised specialist retailer.
Prior to using the pushing aid, please check whether all parts
attached have been fastened properly.
The user (pusher) must be mentally and physically capable of
operating the Togo pushing aid.
The values given in the operating instructions for the wheelchair,
in particular air pressure, max. incline and max. user load must be
adhered to.
The pushing aid may only be operated by one assisting person
(pusher).
The wheelchair user (user) may not use the Togo pushing aid
themself as a wheelchair drive unit.
Please use ramps to avoid obstacles where possible.
Anti-tippers are a requirement when moving on inclines of 8% or
more.
The maximum incline allowed is 10%.
Ledges or kerbs should only be negotiated with the pushing aid
drive disconnected or after removing the pushing aid.
The control unit must always be switched off when leaving or
getting into the wheelchair.
Observe the road traffic regulations when on the road.
The optional lighting on the wheelchair must at all times be visible
to other road users.
If possible, wear bright, noticeable clothes. You will then be seen
better by other traffic participants.
After use, switch off the pushing aid and secure the Togo against
unauthorised use by removing the key.
Bischoff & Bischoff GmbH | 09.01.2020 - Revision: 1
TOGO
pushing aid |
23

Publicité

Table des Matières
loading

Table des Matières