Publicité
Les langues disponibles
Les langues disponibles
- Screw in or out the hex bolt (2) to adjust.
- Then tighten the hex nut (1).
Now the bow return stroke will stop at the set position.
6.11 ADJUSTING THE BOW PIVOT STROKE
The bow can pivots from 0
31
Stop at 0°
Fig 37
- Release the hex nut (32 Fig 37 & 38).
- Screw in or out the hex bolt (31 Fig 37 & 38) to adjust.
- Then tighten the hex nut (32).
6.12 ADJUSTING THE FRONT BLADE GUIDE UNIT
WARNING!
This adjustment must be repeated every time the section of the workpiece changes.
107
Fig 39
To get the maximum accuracy and safety during the cut (i.e. with a very small portion of blade not covered by the
guard) the blade guide unit (C) must be as close as possible to the piece to be cut.
- Release the blade guide arm by operating the piece to be cut.
- This way the arm will not make contact with the piece during its stroke; then retighten the arm.
6.13 STOP THE SAW
To stop the saw band from rotating while operating simple release the handgrip control (A Fig 1).
The machine can also be brought to a stop by pushing the emergency (f Fig 47 & 48).
The machine can also be brought to a stop by turning the total switch to position "OFF" (d Fig 47 & 48) or to
position "0" (e Fig 47 & 48)).
The machine can also stop when the cut is completed.
6.14 AFTER USE
After use all machining residues or other humid or dusty materials must be cleaned from the machine. Keep the
machine clean and in good condition. It will continue to give better results.
WARNING!
After use always make sure that the electric power supply has been disconnected.
o
o
o
to 60
. To adjust the 0
32
31
Stop at 60°
105
C
o
and 60
, proceed as follows:
32
Fig 38
Fig 40
38
Publicité
