Publicité
Les langues disponibles
Les langues disponibles
3.
Type
1
and press
the same speed as the Ethernet switch to which it is attached. After you press
be returned to the Network Configuration menu.
4.
Type
2
and press
Configuration Protocol (DHCP) address.
A static IP address may be used to provide a user-defined IP address, netmask and default
gateway for the DSR switch. Avocent recommends using a static IP address for ease
of configuration.
DHCP is a protocol that automates the configuration of TCP/IP-enabled computers. When
DHCP is selected, the IP Address, Netmask and Default Gateway settings are automatically
assigned to the DSR switch and may not be modified by a DSR switch user.
If you are using the DHCP option, please configure your DHCP server to provide an IP address
to the DSR switch and then skip step 5.
5.
Select the remaining options from the Network Configuration menu to finish the configuration
of your DSR switch with an IP address, netmask, default gateway and ping response.
6.
Type
0
(zero) and press
Other Console Main Menu Options
Besides the Network Configuration option, the Console Main menu of the DSR switch features the
following menu items: Security Configuration, Firmware Management, Enable Debug Messages,
Restore Factory Defaults, Reset Appliance and Exit. Each menu item is discussed in this section.
Security Configuration
The Security Configuration menu contains the following options:
•
Console Password: Enable or disable using security for the console (access requires an
Admin account).
•
Unbind from DSView 3 Server: Reset the certificate used by the DSView 3 software system.
Console Password
If this is enabled, access to the switch's Console Main menu will require an appliance administrator
to log in.
Unbind from DSView 3 Server
This option enables you to clear the certificate sent by the DSView 3 software to the DSR switch.
When a DSR switch is added to a server running DSView 3 software, a certificate is downloaded
from that server to the DSR switch automatically. If its system replicates certificates, it will pass
the certificate to the servers in that certificate replication system. All servers in that system will
then be allowed to access the DSR switch. All servers that are not part of that system will be
locked out.
All manuals and user guides at all-guides.com
Enter
to set your network speed. For best performance, set the DSR switch at
Enter
to specify whether you are using a static or Dynamic Host
Enter
to return to the Console Main menu.
Chapter 6: Terminal Operations
, you will
Enter
65
Publicité
