Publicité
Les langues disponibles
Les langues disponibles
32
DSR Switch Installer/User Guide
6.
Click OK to save settings.
-or-
Click X to exit without saving changes.
Setting the keyboard country code
NOTE: Using a keyboard code that supports a language different from that of your DSR switch firmware will
cause incorrect keyboard mapping.
Sun servers may use keyboard mappings for non-US keyboards. By default, the DSR switch sends
the US keyboard country code to Sun and USB modules attached to target devices, and the code is
applied to the target devices when they are powered up or rebooted. Codes are then stored in the
DSRIQ module.
Issues may arise when you use the US keyboard country code with a keyboard of another country.
For example, the
keyboard. Sun servers will interpret pressing the
when the US keyboard country code is used.
The Keyboard dialog box enables you to send a different keyboard country code than the default
US setting. The specified country code is sent to all target devices attached to the DSR switches
when they are powered up or rebooted, and the new code is stored in the DSRIQ module.
NOTE: If a DSRIQ module is moved to a different target device, the keyboard country code will need to be reset.
See Sun Advanced Key Emulation section on page 97 for information on emulating certain Sun
keys using a PS/2 keyboard and special considerations for Japanese and Korean Sun
USB keyboards.
NOTE: Only local users can view or change keyboard country code settings.
To set the keyboard country code for Sun servers:
1.
If the OSCAR interface is not open, press
2.
Click Setup - Keyboard to open the Keyboard dialog box shown in Figure 3.14.
All manuals and user guides at all-guides.com
key on a US keyboard is in the same location as the
Z
key on a German keyboard as pressing the
Y
Print Screen
to open the Main dialog box.
key on a German
Y
key
Z
Publicité
