Publicité
Les langues disponibles
Les langues disponibles
Table 4.4: Viewing Appliance Information (Continued)
To do this:
Enter, change or display the unit's network
address, gateway address, subnet mask, MAC
address, LAN speed, DHCP enable status or ICMP
ping reply status
Display the unit's current firmware revision for
application, boot and Video FPGA
Display a list of the attached IQ module and
its status
Display a list of active KVM sessions and
their duration
Display a list of active sessions
Display a list of devices attached to the DSR switch Appliance - Connections
VIew the unit's part number, serial number and
EID number
Enter or display the unit's Site, Department
and Location
Enable the Inactivity Timeout
Change the unit encryption level
Change the modem time-out settings
Power Controlling Target Devices
NOTE: You must have administrator privileges to change power control device settings.
If a target device is connected to a power control device outlet, you may power up, power down or
cycle (power target device down and then up) the target device using the DSR switch on-board
web interface.
To power up a target device:
1.
Select Appliance - Appliance Settings - Ports - Power Units from the DSR Explorer window.
2.
Click the name of the unit you wish to power up, and select Sockets.
3.
Select the checkbox to the left of the device that you wish to power.
4.
Click the On button.
All manuals and user guides at all-guides.com
Chapter 4: Web Interface Operations
Select this:
Appliance - Appliance Settings - Network
Appliance- Appliance Settings - Versions
Appliance - Appliance Settings - Ports - IQ modules
Appliance - Appliance Settings - Sessions - Active
Appliance - Appliance Settings - Sessions - Active
Appliance - Properties - Identity
Appliance - Properties - Location
Appliance - Appliance Settings - Sessions - KVM settings
Then click the Enable Inactivity Timeout box
Appliance - Appliance Settings - Sessions - KVM settings
Then select the level of encryption desired for keyboard/
mouse signals and then video signals
Appliance - Appliance Settings - Ports - Modern
47
Publicité
