Publicité
Les langues disponibles
Les langues disponibles
To install the rack mounting bracket:
1.
Remove the two rack mounting screws from each side of the DSR switch.
2.
Place the rack mounting brackets next to the switch as illustrated in Figure 2.2.
3.
Insert the screws supplied with the rack mounting kit through the holes of the brackets and into
the DSR switch. Tighten the screws securely.
Install the DSR switch into the rack using the approved method of the rack manufacturer.
Figure 2.2: DSR Switch Mounting Diagram
Connecting the DSR Switch Hardware
To connect and power up your DSR switch:
1.
Power down the target device(s) that will be part of your DSR switching system. Locate the
power cord that came with the DSR switch and plug the appropriate end into the power socket
on the rear of the DSR switch. Plug the other end into an appropriate AC wall outlet.
NOTE: To avoid potential video and/or keyboard problems when using Avocent products: If the building
has 3-phase AC power, ensure that the computer and monitor are on the same phase. For best results, they
should be on the same circuit.
WARNING: To reduce the risk of electric shock or damage to your equipment:
-
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
-
Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.
-
Disconnect the power from the switch by unplugging the power cord from either the electrical outlet or
the appliance.
-
The AC inlet is the main power disconnect.
2.
Disconnect the power from the switch by unplugging the power cord from either the electrical
outlet or the appliance.
All manuals and user guides at all-guides.com
Chapter 2: Installation
9
Publicité
