Publicité
Les langues disponibles
Les langues disponibles
Operation
1.
Connect the power cable to an easily accessible, standard electrical so-
cket.
Attention: Check that the voltage specifications of the machine cor-
respond to that of your power supply network (220 - 240 V /
50 Hz).
2.
Switch on the power switch at the rear of the device and then switch on
the On/Off button (ON/OFF) on the operating panel.
3.
The drive motor for the transport rollers starts up, the red LED (Power)
lights up and the warm-up phase begins.
4.
The correct operating temperature is reached after about 4 - 6 minutes
and the green LED (Ready) lights up.
5.
Set the thickness of the laminating pocket using the Up and Down but-
tons, if it needs to be altered.
Note:
Only use laminating pockets of at least 80 μm and maximally
250 μm.
6.
Insert the document to be laminated in the foil pocket so that there is a
margin of approx. 3 - 5 mm to the edge of the foil on all sides.
Attention:
7.
Insert the foil pocket containing the document in the laminator's inserti-
on slot. Insert the ready closed side of the foil in first. The foil pocket,
with the document inside, is automatically drawn in and sealed.
Note:
To prevent the foil pocket from creasing, never feed the
open side of the laminating pocket first in the insertion slot of
the laminator.
Attention: The foil is very hot and soft when ejected following lamina-
tion. Therefore, handle the laminated product with extreme
care.
Note:
To flatten the laminated product, place a book or similar
heavy, flat object, on it.
Note:
If the device is used continuously, the blue LED may light up
occasionally to indicate reheating. This does not affect the
quality of the lamination process.
All manuals and user guides at all-guides.com
Only use hot laminating foils.
17
Publicité
