Kohler Prim R706534-8L-SHP Guide D'installation page 6

3. Install the Centerguide
Measure the center of the threshold. Mark the centerline near the groove on the inside surface of the
threshold.
IMPORTANT! Drill through the inside surface only.
Drill a 1/8" hole at the centerline on the groove of the inside surface of the threshold.
Install the centerguide clip to the threshold with the supplied #6 x 3/8" screw.
Press the centerguide over the clip. Make sure the centerguide is completely installed with the tabs
snapped under the bottom of the threshold.
1380408-2-B
All manuals and user guides at all-guides.com
Inside
Surface
Groove
1/8"
(3 mm)
Hole
6
Tabs
Kohler Co.