Publicité
Les langues disponibles
Les langues disponibles
12. Install the Connectors to the Headers
Locate the notches along the inside tracks of the headers.
Mark the locations with pieces of tape on the outside of the headers. This will help with door panel
installation later.
NOTE: Inner and outer headers are identical.
Push a header connector into the end of each header as shown. The hex screw head should be
visible.
Position each connector approximately 2" (51 mm) from the ends of the headers so they are clear of
the brackets during header installation.
Kohler Co.
All manuals and user guides at all-guides.com
Notches
15
Tape
Setscrew
2"
(51 mm)
1380408-2-B
Publicité
