Atag OX9511H Notice D'utilisation page 64

USE
P
A
U
T
O
P
A
U
T
O
P
A
U
T
O
EN 10
4. Set a baking function and temperature.
If the end time is reached, the oven is switched off and an acoustic
signal goes off.
5. Press any key to switch off the acoustic signal.
The oven remains switched off and the 'AUTO' symbol flashes.
6. Hold the 'time button' in for a few moments till you hear a beep
to end the function. Turn the oven function knob and temperature
knob to the 'off position' to switch the oven off.
An end time can still be set while the oven is in use. Follow the
instructions above to do so (in that case the oven function and
temperature do not have to be reset).
You can check the end time of the baking process whenever you
wish by holding the 'time button' in for a few moments. If you want to
change the end time, you should cancel the function by simultaneously
pressing the '–' and '+' buttons. Then set an end time again.
Setting baking time and end time
1. Hold the 'time button' in for a few moments till you hear a beep. If
the 'time button' is then pressed again, the word 'time' appears in
the display.
2. Set the baking time using the '–' and '+' buttons.
3. Press the 'time button' again till the word 'End' appears in the
display.
4. Set the end time with the '–' and '+' buttons.
You will hear a beep, the current time appears and the 'AUTO'
symbol stays lit.
5. Set a baking function and temperature.
The oven remains switched off, with the 'AUTO' symbol in the
display. The oven has been programmed.
The oven starts when the baking process should begin and bakes for
the baking time set. The 'AUTO' symbol and the heat symbol.