Philips SCD588 Mode D'emploi page 8

Baby unit
You can use the baby unit corded or battery operated. Even if
you are going to use the unit corded, we advise you to insert
batteries.This guarantees automatic back-up in case of power
supply failure.
Operation using AC power adapter
1 Connect the power adapter cord (A-11) to the power supply
jack (DC 9V / 300mA - A-10) of the baby unit.
2 Connect the AC power adapter (A-11) to a wall outlet.
➜ The baby unit is now ready for cord operated use!
Battery operated use
1 Open the battery compartment by turning the cover (A-9) to
the left (C OPEN), using the palm of your hand.Take the
cover off.
2 Insert four 1.5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied; we recommend Philips Alkaline batteries).
3 Put the battery compartment cover (A-9) back in place.
Close the compartment by turning the cover (A-9) to the
right (CLOSE B), using the palm of your hand.
➜ The baby unit is now ready for battery operated use!
Preparing your baby monitor
EN
9