Dri-Eaz DrizAir 1200 Manuel Du Propriétaire page 10

Owner's Manual
1. Turn the power off using the OFF key, and let the unit sit plugged in for about
10 minutes. This allows water to drip from the coils and collect in the drip pan.
2. Press PURGE to remove residual water.
DEFROST MODE
During normal operation, the temperature sensor detects frost forming on the coils,
causing a defrost cycle to start. The display will read DEFROST ON. Dehumidification
stops during the defrost cycle. When the unit completes the cycle, the display returns
to DEHUMIDIFIER ON.
ERROR MESSAGES
If the 1200's onboard diagnostics discover a problem, the unit will display "GET
SERVICE," followed by "ER" and a numeral from 01 to 09. If this message appears, first
follow these steps:
1. Unplug the unit and then plug it back in. This may re-set the electronics.
2. If the error message reappears, try the solution (if one is listed) in the
Warnings
3. If the error message still appears, please contact the Dri-Eaz Service Department
at 888-867-3235.
1.6 Error Messages
The table below shows error message that the system may detect. If the display shows
an "ER" message, first unplug the unit and then plug it back in. This may re-set the
electronics, and if so, no further action is required. If the error message reappears, try
the solution shown under "Explanation." If this still does not fix the problem, Contact
your local authorized distributor.
DrizAir 1200 Owner's Manual108998K
" section.
10
10
"Error and
© 2023 Legend Brands, Inc.