STERWINS EGT2-25.3 Mode D'emploi page 252

5.TROUBLESHOOTING
Problems
Product does not
start
Product does not
reach full power
Unsatisfactory
cutting
performance
Excessive
vibration or noise
EN
Possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect to the
product
Extension cord not suitable for
operation with this product
Power source (e.g. generator)
has too low voltage
Air vents are blocked
Cutting attachment is worn
Cutting attachment is dull/
damaged
Bolts/nuts are loose
252
Solution
Connect to power supply
Check by a specialist electrician
Check by a specialist electrician
Use a proper extension cord
Connect to another power source
Clean the air vents
Replace with a new one
Replace with a new one
Tighten bolts/nuts