Hitachi WF 4DY Mode D'emploi page 4

Masquer les pouces Voir aussi pour WF 4DY:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
English
CHARGING
Before using the automatic screwdriver, charge the battery
as follows.
1. Connect the charger's power cord to an AC outlet.
When the power cord is connected, the charger's
pilot lamp will blink. (At 1-second intervals).
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the ventilation slots of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 2 and 3.)
CAUTION
If the batteries are inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause the fuse to blow, or problems in
the charger such as a deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light up.
When the battery becomes fully recharged, the pilot
lamp will blink. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
Table 1
Before charging
While charging
Charging complete
Charging impossible
(2) Regarding recharging time
Depending on the combination of the charger and
batteries, the charging time will become as shown
in Table 2.
Table 2 Charging time (At 20°C)
Charger
Battery
EB12, EB12S
EB12B, EB12M
3
Indications of the pilot lamp
Blinks
Lights for 0.5 second. Does not lights for 0.5 second.
(off for 0.5 second)
Lights
Lights continuously
Blinks
Lights for 0.5 second. Does not lights for 0.5 second.
(off for 0.5 second)
Flickers
Lights for 0.1 second. Does not lights for 0.1 second.
(off for 0.1 second)
UC12Y
Approx. 60 min.
Approx. 105 min.
Nameplate
Latch
Fig. 2
Hole for connecting
the rechargeable
battery
NOTE
The charging time may vary according to embient
temperature and power source voltage.
4. Disconnect the charger's power plug from the AC
outlet on completion of recharging.
5. Hold the charger firmly and pull out the battery.
Regarding electric discharge in case of new batteries,
etc.
As the internal chemical substance of new batteries
and batteries that have not been used for an ex-
Rechargeable
battery
«
Insert
Rechargeable
battery
Pilot lamp
Fig. 3

Publicité

Table des Matières
loading

Table des Matières