Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
99632241_FR_A.qxd
23/12/03
Minor troubleshooting
IF YOU REALIZE THAT
Lighting the burners:
There are no sparks when pressing the buttons.
When lighting a burner, sparks appear at all of the
burners at the same time.
Sparking takes place but the burners do not light
up.
In the low position the flames go out or are too
high.
Flames are irregular.
50
14:43
Page 50
(cont'd)
WHAT SHOULD YOU DO?
Check the electrical connections on the hob.
Check that the sparkers are clean.
Check that the burners are clean and in position.
This is normal. The lighter system is centralised, and
all the burners spark at the same time.
Check that the gas inlet pipe has not been squashed.
Check that the gas inlet pipe tube is less than 2m
long.
Check that the main gas tap is open.
If you use gas tanks or cylinders check that they are
not empty.
If you have just installed the hob or changed the gas
bottle, you should repeat the ignition procedure several
times until the gas reaches the burners.
Make sure the injector is not blocked up. if this is the
case, clear it with a safety pin.
Light up your gas burner before putting a pan on it.
Avoid any severe drafts in the room.
Check that the gas you are using corresponds to the
injectors that have been installed (See injector identifi-
cation in the "Gas Rating" chapter).
Remember that gas hobs are delivered preset for use
with natural gas.
Check that the gas change switch is correctly positio-
ned (please see the chapter on "Changing the type of
gas supply").
Call the After Sales Service dept for the adjustment of
the burner gas flow reduction.
Check that the burners and injectors are clean and as-
sembled correctly.
Check you have enough gas in your gas cylinders.
Publicité
