Saeco Primea Touch Cappuccino Mode D'emploi page 9

6 INSTALLATION
MANUAL PRIMING OF THE WATER CIRCUIT
Manually prime the water circuit only when display (2) appears.
Note: fi rst make sure that the water tank is full.
Important: before performing the circuit priming, position the SBS system (see page 9) as shown on the
display. Then adjust as desired.
1
Position a container under the hot
water spout (it is possible that
water will not come out of the
spout).
SETTING THE LANGUAGE AND THE CLOCK
When the machine is switched-on for the fi rst time, it requires the selection of the desired language.
This allows you to adjust the parameters of the beverages to the typical parameters of the country
where the machine is used. This is why some languages are differentiated also by country.
1
deutsch Italiano (i)
language
english
français
1/2
italiano (ch) nederlands
ok
Select the desired language.
Press for the other languages.
4
self-test
demo
The machine starts and displays
the menu in the selected
language.
All manuals and user guides at all-guides.com
2 priming the machine
position the SBS system as shown
Press the display once and the
machine will begin priming the
water circuit.
2
deutsch
language
français
1/2
italiano (ch)
Press to select the desired
language.
5
self-test
demo
If desired, the "demo" function (see page 26)
may be activated by pressing the key, each time
the machine carries out a self-diagnosis.
3
start
When the prime circuit cycle is
fi nished, remove the container.
The machine is now ready for
use.
3
Italiano (i) deutsch
english
français
nederlands italiano (ch)
ok
Press "ok".
6
See manual on page 34 to
adjust the clock.
Italiano (i)
language
english
1/2
nederlands
ok