Cafe CDT828 Serie Manuel Du Propriétaire page 15

Loading
A loaded middle rack may be heavier than anticipated. To prevent minor injury or damage to
CAUTION
the contents, do not raise or lower the middle rack after the rack is loaded.
On some models, the middle rack allows 2" of adjustment
up or down to accommodate larger items. The middle rack
may be lowered by pushing the long flaps on each side of the
rack. This will allow you to lower the rack. To raise the rack,
lift up on the rack until the rack locks in place.
On some models, the middle rack may be adjusted to
accommodate larger items. To adjust the middle rack, fully
extend the middle rack and lift the front of the rack so that the
rack roller wheels clear the end hooks on the front of the rails.
Continue to pull the rack until the remaining rack roller wheels
clear the end hook. Select the set of rollers on the side of the
rack that provides the desired height, and reinstall the middle
rack by aligning the rack roller wheels on the end hook and
rack rails – Ensure that there are roller wheels above and
below the rack rails. Failure to properly align the wheels onto
the end hook and rails may result in the rack falling from the
dishwasher.
To add flexibility in loading, the CustomFit Lid Caddy (on
some models) may be placed in the up or down position.
The CustomFit Lid Caddy is designed to secure difficult
to fit items such as lids, blender blades, and/or small
sauce/dip bowls.
The fold down tines (on some models) provide flexibility
for extra-large and hard-to-fit items. The tine rows can be
adjusted to a vertical or lay-down position.
14
Middle Rack
Middle
Rack
Rail
Rack Rollers
Rail End Hook
Pull rack out,
lift up and over
rail end hooks,
and pull out to
Rail
remove
End
Hook
49-4000289 Rev 0