Sony CDX-M9900 Mode D'emploi page 20

Receiving the stored stations
1
Press (SOURCE) repeatedly to select
the radio.
2
Press (MODE) repeatedly to select the
desired band.
Radio reception of the desired band starts.
Operation by the card remote commander:
To
Stop radio
reception
Receive stored
stations
– Preset search
Search stations
– Automatic tuning
Specify
frequencies
– Manual tuning
Operation by the main unit:
To
Stop radio
reception
Receive stored
stations
– Preset search
Search stations
– Automatic tuning
Specify
frequencies
– Manual tuning
* To stop searching, rotate the R dial in the reverse
direction.
Tip
If automatic tuning stops too frequently, set "Local" in
"PlayMode" to "ON." Only the stations with relatively
strong signal will be tuned in (Local seek mode).
20
Press (OFF).
Press (1) to (6).
Press M/m
[until the desired station].
Press </,
[until the desired station].
Press </,
[hold until the desired
frequency].
Press (OFF).
Rotate the R dial
[until the desired station].
Press (ENTER) once, then
rotate the R dial*
[until the desired station].
Press (ENTER) twice, then
rotate the R dial
[until the desired
frequency].
If FM stereo reception is poor
— Mono
Set "Mono" in "PlayMode" to "ON."
The sound improves, but becomes monaural.
To restore stereo reception, set to "OFF."
Note
If interference occurs, this unit will automatically
narrow the range of reception frequency to eliminate
noise (IF Auto function). In such cases, some FM
stereo broadcasts may become monaural while in the
stereo reception mode.
Tips
• To always hear FM stereo broadcasts in stereo, set
"IF Switch" in "PlayMode" to "WIDE." Note that some
interference may occur in this setting.
For details, see "PlayMode menu" on page 38.
• If FM broadcasts are difficult to hear, set "DSO" in
"Sound" to "OFF" (page 30).
Storing only desired stations
You can manually preset the desired stations on
any chosen preset memory.
1
Press (SOURCE) repeatedly to select
the radio.
2
Press (MODE) repeatedly to select the
desired band.
3
Press < or , to tune in the station
that you want to store.
4
Press the desired number button ((1)
to (6)) for 2 seconds until "Memory"
appears.
The number of the button you pressed is
displayed, and then the selected station is
assigned to this number and stored.
Note
If you try to store another station on the same stored
number, the previously stored station will be erased.