Télécharger Imprimer la page

Bosch B36 Serie Notice D'utilisation page 6

Réfrigérateur / congélateur combiné

Publicité

Les langues disponibles

Les langues disponibles

en-us
Scope of Delivery
After unpacking all parts, check for any damage
in transit.
If you have any complaints, please contact the dealer
from whom you purchased the appliance or our
Customer Service department.
The following parts are included:
Built-in appliance
Interior fittings (depending on model)
Bag containing installation materials
Operating Instructions
Installation Instructions
Customer Service Booklet
Warranty enclosure
Information on the energy consumption and noises
Connecting the Appliance
Have a technician install and connect the appliance
according to the enclosed Installation Instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until
the appliance has been installed.
Always connect the water before the power.
Apart from statutory national regulations, you should
comply with all applicable local electricity and water
companies codes and requirements.
After installing the appliance, wait at least 1 hour before
switching the appliance On. During transportation
the oil in the compressor may have flowed into
the refrigeration system.
Before switching the appliance On for the first time,
clean the interior of the appliance (see chapter
"Cleaning the Appliance").
Water Connection
,
CAUTION:
Connect the appliance to a drinking water line
only:
Minimum pressure: 0.2 Mpa (2 bar)
Maximum pressure: 0.8 Mpa (8 bar)
Pressure over 0.8 MPa (8 bar): install
a pressure limiter between drinking water
connection and hose set:
The water may be connected only by a competent fitter
according to the local regulations of the appropriate
Water Supply company.
A cold water connection is necessary for operating
the automatic Ice Maker. The water pressure must be
between 29 and 116 p.s.i. (2.0 and 8.0 bar). The
installation must correspond to the local plumbing
regulations.
A separate Shut-Off-Valve should be installed in
the cold-water inflow.
The Shut-Off-Valve should not be located behind
the appliance. It is recommended that you mount
the Shut-Off-Valve directly next to the appliance or at
another place that is easily accessible.
6
When installing the water connection, pay attention to
the permissible installation area for the water line.
For connection to the drinking water line use only water
pipes that are suitable for drinking water. Observe
national regulations and the connection conditions of
the local Water Supply companies.
Electrical Connection
,
WARNING:
Avoid the risk of an electric shock!
,
WARNING:
Insert into a grounded 3-phase receptacle. Never
remove grounding phase. Do not use any
adapters. Do not use any extension cords.
,
WARNING:
Non-compliance with these instructions may
result in death, fire or an electric shock.
Improper connection of the protective conductor
may result in an electric shock. If you are in
doubt whether the appliance has been grounded
properly, have the appliance tested by
a qualified electrician or service technician.
Do not use extensions or distributors.
The receptacle must be installed according to the
Installation Manual.
The appliance complies with protection class I.
Connect the appliance to 115 V/60 Hz AC through
a correctly installed 3-pole grounded receptacle.
The receptacle must be protected with a 10 to 16 A
fuse.
The appliance comes with a UL registered 3-wire
Power Cord.
Please see the following table:
Appliance
Maximum Simultaneous Load
Fridge-
6.0 amps
freezer
Check on the Rating Plate whether the indicated
voltage and current type correspond with the values of
your power supply. The location of the Rating Plate
can be found in the chapter "Customer Service".
,
WARNING:
Never connect the appliance to electronic
energy saving devices.
Our appliances can be used with power line and
sine-controlled inverters. Power line-controlled
inverters are used for photovoltaic systems
which are connected directly to the national grid.
Sine-controlled inverters must be used for
isolated applications (e.g. on ships or
in mountain lodges) which are not connected
directly to the national grid.

Publicité

loading

Ce manuel est également adapté pour:

B30 serie