Publicité
Les langues disponibles
Les langues disponibles
rough framing
EN
3.2
manifold installation
1. Slide the manifold into the back of the sleeve (step A) until the slots engage the top tab in the sleeve (step B)
(see above).
Some components and framing
hidden for clarity.
MANIFOLD
2. For front discharge: Install 2 screws through the holes along the front and 1 screw along the side of the
manifolds (see below).
note:
There are optional securing holes along the bottom of the sleeve.
3. For side discharge: Install 4 screws through the holes along the front of the manifold (see below). Repeat on
opposite side.
note:
There are 4 optional securing holes along the sides and bottom of the sleeve.
Front discharge
OPTIONAL
note:
When installing the manifolds for front discharge, the manifolds must
be installed at both ends of the sleeve leaving the middle section open.
10
W415-2968 / C / 03.29.23
SLOT
SLEEVE
OPTIONAL
Type 1
TOP TAB
Side discharge
OPTIONAL
OPTIONAL
Publicité
