GE GTDL740EDWW Instructions D'utilisation page 15

Remove and swap the cover cap and door handle from the
5
outer door:
Squeeze the tabs on the inside of the door handle clips.
Push clips through the outer door.
Squeeze the tabs on the inside of the cover cap.
Push cap through the outer door.
Cover
strip
Push the door handle clips into the openings on the
handle so it curves to the inside.
Push the cover cap into the openings on the outer door
where the handle was removed.
Inside of door
Door handle clip
Door handle
All manuals and user guides at all-guides.com
Installation Instructions
Inside of door
Door handle
Door handle clip
Inside of door
Cover strip
When the cover cap and door handle are in place, mount the
6
inner door back into the outer door with the screws removed in
step 4. Make sure you mount the hinges on the side opposite
the handle.
Inside screws
Edge
screws
Mount the assembled door on the 2 upper left side hinge
7
screws installed in step 2.
Move the hinge screws loosened in step 3 into the lower left
Door
Install the 4 plastic caps removed in step 1 into the 4 right side
8
front panel holes.
NOTE: To return the door to the original setup, follow threse
instructions, swapping "left" and "right".
15
Inside screws
Edge screws
Handle
Hang door and
tighten screws
Door hinge
screws
Edge
screws