Publicité
Les langues disponibles
Les langues disponibles
CONNECTING INLET HOSES
14
(on some models)
To produce steam, the dryer must connect to the cold water supply.
Since the washer must also connect to the cold water, a "Y" connector
is inserted to allow both inlet hoses to make that connection at the
same time.
NOTE: Use the new inlet hoses provided; never use old hoses.
Turn the cold water faucet off. Remove the washer inlet hose from
Attach the female end of the "Y" connector to the male coupling of
''Y'' Connector
inlet hose to the other male end of the "Y" connector. Tighten by
1" = 2.5 cm
1' = 0.3 m
All manuals and user guides at all-guides.com
Installation Instructions
WATER
WATER
14
Using pliers, tighten all the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the couplings may result.
Turn the water faucet on.
Check for leaks around the "Y" connector, faucet and hose couplings.
WATER SUPPLY REQUIREMENTS
Hot and cold water faucets MUST be installed within 42 in. (107 cm)
of your washer's water inlet. The faucets MUST be 3/4" (1.9 cm)
garden hose-type so inlet hoses can be connected. Water pressure
MUST be between 10 and 120 pounds per square inch. Your water
department can advise you of your water pressure.
NOTE: A water softener is recommended to reduce buildup of scale
inside the steam generator if the home water supply is very hard.
REGISTER YOUR NEW APPLIANCE TO RECEIVE ANY
IMPORTANT PRODUCT NOTIFICATIONS.
Please go to www.GEAppliances.com
(www.geappliances.ca in Canada)
or mail in your Product Registration Card.
For questions on installation, call: 800-626-2000 (US)
or 800-561-3344 (Canada)
11
Publicité
