DeWalt DW650 Mode D'emploi page 23

All manuals and user guides at all-guides.com
• Adjust the height of the sanding frame (14) using
the knob (18).
• To remove the sanding frame, proceed in reverse
order.
If the sanding frame is not being used,
the crankshaft (13) can simply be rotated
a quarter of a turn and left in the tool.
Mounting and removing the stationary stand
(DE6501) (fig. A & F)
The Belt Sander can be used as a stationary tool.
The stationary stand is available as an option.
• Mount the sanding frame (14) as described above.
• Remove the star knob (19) from the stationary
stand.
• Place the belt sander on the stationary stand (20).
The guiding handle (9) locates in the hole in the
stationary stand (20). The threaded spindle (21)
protrudes from the hole (22) in the bracket (23).
• Turn the star knob (19) onto the threaded
spindle (21).
• To remove the stationary stand, proceed in
reverse order.
Dust extraction
Dustbag (fig. G)
• Squeeze the spring (24) of the dustbag (7) and
release it between the fixing rings (25).
• For efficient dust extraction empty the dustbag
when it is about one third full.
• Remove the dustbag, open the zipper and gently
shake out the dustbag.
Dust extraction adaptor (DE6502) (fig. E & H)
• Screw the dust extraction adaptor (8) onto the
outlet (26).
• Whenever possible, connect a dust extraction
device designed in accordance with the relevant
regulations regarding dust emission.
Do not use a dustbag or vacuum
extractor without proper spark protection
when sanding metal.
17
Do not sand magnesium!
• Do not rough sand pure metal surfaces.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Make sure all materials to be sanded are
well secured.
• Apply only a gentle pressure to the
workpiece.
Sanding (fig. A)
A guiding handle (9) has been provided for optimum
tool control when using the Belt Sander without the
stationary stand.
• Start with the coarsest grit size.
• Move the belt sander in long, sweeping strokes.
• Check your work at short intervals.
Switching ON and OFF (fig. A)
• Switching ON: press the ON/OFF-switch (1).
• For continuous operation, also press the lock-on
button (3).
• To stop the tool in continuous operation, press
the switch briefly and release it. Always switch
OFF the tool when work is finished and before
unplugging.
Your dealer can provide detailed information on
sanding sheets.
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your Power Tool requires no additional lubrication.
E N G L I S H
en - 5