Tecno-gaz ONYX B 6.0 Mode D'emploi page 89

15
Messages of error are emphasized through an Alfa-numerical code, consisting in a letter
and three numbers.
If an alarm message is diplayed (code "A") the cycle is to be considered
aborted: it will be necessary to repeat all the preparation and sterilization
operations.
To reset alarms and errors hold down at the same time the buttons under the bar indicated
with Reset.
ERROR
A 001 Cycle interrupted by the user
A 101 Vacuum not archieved in 10 min.
Vacuum not maintained on the first
A 111
phase of VACUUM TEST
Vacuum not maintained on the second
A 121
phase of VACUUM TEST
During preheating phase the autoclave
A131
did not load right water amount
A132 Error in the flow-meter operation
Pressure above the allowable limit
A133 during the water recall for the warmup
phases
A 200 Error in the control of the EV operation
A 400
A 401
Error in the locking operation
A 403
A 405
A 551 Pressure out of limit
A 637 Error in the access to the memory card
Reading of the T1 probe during
A 651
sterilization above the maximum limit
MESSAGES OF ERRORS
CAUSE SOLUTION
 Reset and restart the system
 Check the gasket
 Check the door adjustment
 Reset and restart the system
 Check the gasket
 Check the door adjustment
 Reset and restart the system
 Check the gasket
 Check the door adjustment
 Reset and restart the system
 Reset and restart the system
 Reset and restart the system
 Reset and restart the system
 Reset and restart the system
 Reset and restart the system
 Let cool the room
 Reset and restart the system
 Check that the SD card is correctly
inserted
 Chech SD card: lever might have
moved on "lock" position
 Reset and restart the system
 Let cool the room
 Reset and restart the system
ENGLISH
41