Hitachi M 12V Mode D'emploi Et Instructions De Securite page 18

English
Bit
Template
Guide
Fig. 14
Template guide
Template guide
adaptor
Template guide
Fig. 15
3. Adjusting the rotating speed (Model M12V(S), M8V(S) only)
Fig. 16
4. Cutting
Fig. 17
18
Template
Template
guide
The M12V(S) and M8V(S) have an electronic control
Dial
system that allows stepless rpm changes.
As shown in Fig. 16, dial position "1" is for minimum
speed and position "5" for maximum speed.
(1) As shown in Fig. 17, remove the bit from the
Separate
A template is a profiling mold made of plywood
or thin lumber. When making a template, pay
particular attention to the matters cescribed blow
and illustrated in Fig. 14.
When using the router along the interior plane of
the template, the dimensions of the finished
product will be less than the dimensions of the
template by an amount equal to dimension "A",
the difference between the radius of the template
guide and the radius of the bit. The reverse is frue
when using the router along the exterior of the
template.
Secure the template to the workpiece. Feed the
router in the manner that the template guide
moves along the template as shown in Fig. 15.
Template Guide Adaptor:
If you are using a template guide adapter,
it is possible to use template guides
produced by other firms. The template
guide adaptor, like the template guide, is
attached to the base with two accessory
screws. Attach template guides made by
other firms to the template guide adaptor.
work pieces and press the switch lever up to the
ON position. Do not start cutting operation until
the bit has reached full rotating speed.