Hitachi M 12V Mode D'emploi Et Instructions De Securite page 17

2. Guiding the Router
Wing
bolt (A)
M6✕15
Lock spring
Guide plane
Straight guide
Fig. 10
Lock
Wing bolt (A)
spring
(M6✕15)
Guide plate
Fig. 11
Fig. 12
Template guide
Fig. 13
(1) Straight Guide (Model M12V(S), M12SA(S)):
Guide bars
Feed screw
Wing bolt (C)
Bar holder
Guide bars
Parallel
guide
(2) Parallel Guide (Model M8V(S), M8(S)):
(3) Template Guide:
Use the straight guide for chamfering and groove
cutting along the materials side. First of all, as
shown in Fig. 10, attach the two wing bolts (A)
(M6✕15) and the two lock springs (both standard
accessories) to the screw holes on the top side of
the base. Use the feed screw and the wing bolt
(C) M6✕10 to attach the bar holder to the straight
guide. Insert the guide bar in the hole on the
base. Attach and tighten the two wing bolts (A)
(M6✕15) in the approximate position. Use feed
screw to make minute adjustments of the
measurements from the bit to the guide plane.
Tighten wing bolt (C) M6✕10 and secure straight
guide.
As shown in Fig. 12, securely attach the bottom
of the base to the processed surface of the
materials. Feed the router while keeping the
guide plane on the surface of the materials.
Use the parallel guide for chamfering and groove
cutting along the materials side. First of all, as
shown in Fig. 11, attach the two wing bolts (A)
(M6✕15) and the two lock springs to the screw
holes on the top side of the base. Insert the guide
bar in the hole on the base and adjust the distance
from the bit to the guide plane. Tighten the two
wing bolts (A) (M6✕15) to secure the parallel
guide.
As shown in Fig. 12, securely attach the bottom
of the base to the processed surface of the
materials. Feed the router while keeping the
guide plane on the surface of the materials.
Use the template guide when employing a
template for producing a large quantity of
identically shaped products.
As shown in Fig. 13, secure the template guide to
the base of the router with two accessory screws.
At this time, ensure that the projection side of the
template guide is facing the bottom surface of
the base of the router.
English
17