Helo Magma Instructions D'installation Et D'utilisation page 14

REWARD YOURSELF
Instructions for use and installation MAGMA and SKLA
SAUNA HEATER
1101 – 181
1101 - 210 400V 3N~
1101 - 262
CONTROL PANEL + CONTACTOR BOX
1418-22-1517-3
1418-22-1517
SAUNA HEATER
1101 – 181
1101 - 210 400V 3N~
1101 - 260
CONTROL PANEL + CONTACTOR BOX
1601-12
1601-13
USING.
Before you start to install and use the sauna heater check the following:
- that you have got all the parts needed.
- check that the voltage of the heater and the control box is the right one and that the control box suits your heater.
- chech that the effect of the heater suits your sauna. You must not exceed or go below the volumes mentioned in table 1.
- look at the installation distances in fig. 1. You have to follow these, otherwise it can cause a burn.
- study these installation- and using instructions carefully.
NOTE! Prior to switching the heater on, ensure that the sauna room is ready for heating
HOW TO CHOOSE THE EFFECT OF THE HEATER.
Noticing the volume of the sauna you choose the effect of the heater according to table 1. The volumes mentioned in table 1
are valid under the assumption that the sauna is well insulated. If there are walls of bricks or concrete in the sauna you have
to add to the volume about 1,2m
according to the composed volumes.
+ 2005-1
+ 2005-1
+ 2005-5
+ 2005-5
MAGMA
3
for every brick- or concerete wall m
SKLA
2
and then you choose the effect of the heater
7014102 314 SKLA 54 J