To Start The Engine - Husqvarna 525HE3 Manuel D'utilisation

To fill the fuel tank
WARNING:
follows for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel is
fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
Product overview on page 2 .
refer to

To start the engine

WARNING:
of 15 m/50 ft from persons or animals when
you start the product. There is a risk that the
cutting attachment starts to move.
1. Set the choke control in the choke position.
10
Obey the procedure that
Make sure that there is
Keep a minimum distance
2. Push the air purge bulb until the bulb starts to fill with
fuel.
Note:
It is not necessary to fill the air purge bulb
fully.
3. Hold the body of the product on the ground with your
left hand. Do not put your feet on the product.
4. Pull the starter rope handle slowly until you feel
some resistance, then pull the starter rope handle
with force.
WARNING:
rope around your hand.
5. Continue to pull the starter rope handle until the
engine starts.
CAUTION:
rope to full extension and do not let go of
the starter rope handle. Release the
starter rope slowly to prevent damage to
the product.
6. When the engine starts, put the choke control in the
run position and apply full throttle. The throttle trigger
automatically disengages from the start position.
7. Make sure that the engine operates smoothly.
WARNING:
with a damaged spark plug cap to prevent
electrical shock.
Do not wind the starter
Do not pull the starter
Do not use the product
1173 - 003 - 19.03.2021