Symbols On The Product - Husqvarna 525HE3 Manuel D'utilisation

Symbols on the product

Stop.
This product can be dangerous and cause
serious injury or death to the operator or
others. Be careful and use the product
correctly.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Always wear approved protective gloves.
Use stable boots with non-slip soles.
Stop the product fully before you touch the
cutting tool.
Keep all parts of your body away from the
hot surfaces.
Fuel.
Choke.
yyyywwxxxxx
Note:
Other symbols/decals on the product refer to
special certification requirements for some markets.
1173 - 003 - 19.03.2021
The rating plate shows the serial number. yyyy is the production year and ww is the
production week.
Air purge bulb.
Idle adjustment screw.
High speed needle.
Low speed needle.
There is no electrical insulation in this
product. If the product touches or comes
near high voltage power lines, it can
cause serious injury or death to the
operator. Electricity can move between
different objects by a curve. The higher
the voltage, the longer the electricity can
move. Electricity can also move through
branches and other objects, especially if
the object is wet. Always keep a distance
at a minimum of 10 m/33 ft between the
product and high voltage power lines.
Make sure that the power is off before you
start the work near the power lines. Keep
a distance at a minimum of 15 m/50 ft to
other persons or animals during the
operation.
This product applies with the applicable
EC Directives.
Noise emissions to the environment
according to European Directive
2000/14/EC and New South Wales
legislation "Protection of the Environment
Operations (Noise Control) Regulation
2017". Noise emission data can be found
on the machine label and in the Technical
data chapter.
Euro V Emissions
WARNING:
voids the EU type-approval of this product.
Tampering with the engine
3