Husqvarna TS 138 Manuel D'utilisation page 13

To install the engine cover piece
1. Align the front tab on the engine cover piece with the
cut-out in the engine cover.
2. Align the rear tabs on the engine cover piece with
the cut-outs in the engine cover.
3. Push down the engine cover piece on the engine
cover.
To adjust the seat
1. Sit in the seat.
1701 - 009 - 14.07.2023
2. Lift up the seat adjustment lever (A).
3. Move the seat until it is in a position where you can
push the brake and clutch pedals down.
4. Release the seat adjustment lever (A) to lock the
seat in position.
To connect the battery
WARNING:
burn injuries. Do not use metal wristbands
or other metal accessories. Metal items that
touch the battery terminals can cause burn
injuries, electrical shock, and short circuit of
the battery.
Note:
If it is after the year and month that is written on
the battery label, charge the battery. Charge the battery
for a minimum of 1 hour at 6–10 A.
1. Find the battery location below the seat or the
engine cover.
2. Lift the seat pan or the engine cover to the raised
position.
3. Remove the 2 terminal caps (A) and discard them.
A
Risk of electrical shock and
A
13