Husqvarna TS 138 Manuel D'utilisation page 12

8. Put the steering wheel adapter on the steering shaft
extension.
9. Put the steering wheel on the steering shaft
extension.
10. Make sure that the front wheels and the steering
wheel are aligned forward.
11. Install the large flat washer (H), the lock washer (I),
and the bolt (J). Tighten the bolt fully.
12. Attach the center cover (K) to the steering wheel.
The center cover is attached with snap locks.
To install the seat
1. Remove, but do not discard, the hardware which
attaches the seat to the cardboard package.
2. Remove and discard the cardboard package.
Note:
Do not remove the tape from the adjustment
handle until the seat is correctly attached to the
product.
3. Connect the wire connector to the safety switch (A)
on the seat.
C
D
B
4. Put the seat on the seat pan (B) and put the middle
plastic piece (C) into the middle slot assembly hole
(D).
12
5. Push the seat rearward until the 2 front plastic
6. Fold the seat forward and install the 2 bolts (F) and
E
A
7. Remove the tape from the adjustment lever (I) and
8. Do a check of the operator presence control. Refer
pieces (E) are aligned with the front slot assembly
holes. Push down the seat to engage the plastic
pieces in the slots. Push the seat rearward.
2
the 2 washers (G).
F G
Note:
Make sure that the 2 front plastic pieces (H)
are fully engaged in the seat pan.
Note:
Make sure that the arrows on the 2 washers
point up.
discard the tape.
To do a check of the operator presence control
to
(OPC) on page 8 .
WARNING:
product if the operator presence control
is defective.
1
H
I
Do no operate the
1701 - 009 - 14.07.2023