Beko HNT61110X Mode D'emploi page 11

3 Installation and Use of the Appliance
3.1 Position of the Appliance
• Attention should be paid to the distance be-
tween the hob and hood before installation. This
distance should be 65 cm.
• The measure must be taken from the grill sur-
face on gas hobs and from the glass surface on
electric hobs.
Your new appliance is especially
energy efficient. You will find here
C
some advises on how to save more
energy while using the appliance,
and required to destroy the appli-
ance in a proper way.
3.2 Things to do for energy
saving;
• Ensure sufficient air intake to make the hood
operate efficiently and with low operation noise
during cooking.
• Set the fan level according to the density of
steam in kitchen. Use the high level only when
needed. A lower fan level means less energy
consumption.
• If dense smoke is expected in the kitchen, select
a higher level of fan in advance. It is required to
operate the hood much longer to remove the
smoke already spread all over kitchen.
Kitchen Hood / User Manual
All manuals and user guides at all-guides.com
• Turn off the hood when not in use.
• Clean or replace the filter at intervals stated,
thus, the efficiency of the ventilation is in-
creased and the risk of fire is eliminated.
• 3.3 Installation of the Appliance
C
Use protective gloves and glasses
while performing drilling and cut-
ting operations.
19
10
A
10
MOUNTING TEMPLATE SCALE 1:1
MONTAGESCHABLONE MAßSTAB 1:1
SAGOMA DI MONTAGGIO RELAZIONE 1:1
ESTAMPA DE MONTAJE ESCALA 1:1
GABARIT POUR MONTAGE ECHELLE 1:1
SZABLON MONTAZOWY SKALA 1:1
B
• Drilling Mounting Holes
• Adhere the installation template provided with
the appliance onto the surface on which the in-
stallation will be carried out.
• Drill the holes indicated on the installation tem-
plate with A, B, C, D using a Ø4 mm drill bit.
• Drill a flue outlet hole as stated in the mounting
template with the dimensions provided. Pic. 6
1. Valve Pin Socket
2. Valve Pin
• Insert the plastic pin on the valve (Pic. 7, area 2)
into the pin socket (Pic 7, area 1) found on the
motor outlet. Then, stretch the valve slightly to
insert the other pin on the valve into the other
pin socket. Pic. 7
520
500
462±2
CUT-OUT LINE ON CUPBOARD FOR AIR EXIT
C
AUSSCHNITT IM SCHRANK FÜR LUFTAUSTRITT
LINEA DI TAGLIO PER USCITA ARIA
RECORTE DEL ARMARIO PARA LA SALIDA DE AIRE
LIGNE A COUPER POUR LA SORTIE D'AIR
ZAZNACZYC W SZAFCE OTWÓR POD WYLOT POWIETRZA
248
A,B,C,D = Ø4
D
Pic. 6
Pic. 7
11 / EN