Publicité
Les langues disponibles
Les langues disponibles
Page 2 of 12
TOOLS REQUIRED
•
5MM DRILL BIT + DRILL
•
M6 x 1.00 TAP + TAP WRENCH
•
4mm & 5mm HEX KEYS
ITEM No.
ITEM 1
ITEM 2
ITEM 3
ITEM 4
ITEM 5
ITEM 6
ITEM 7
ITEM 8
ITEM 9
ITEM 10
ITEM 11
THE INSTRUCTIONS BELOW DETAIL TWO SEPARATE FITTING OPTIONS. CHOOSE
•
For all fitting options, when positioning the Chain and Sprocket guard, ensure that:
The lower chain and sprocket area are covered.
o
The flat rear section of the Chain & Sprocket guard should cover the lower section of the
o
sprocket.
The Chain and sprocket guard should be placed in parallel with the chain where it cannot
o
come into contact with any moving components of the motorcycle. Consider any vertical
or lateral movement of the chain and wheel assembly when placing the Chain & Sprocket
guard.
Where bikes are fitted with a lower boss for aftermarket Cotton Reels for use with a
o
paddock stand. Where applicable, the mount block (item 2) can be placed over this
giving greater flexibility when fitting, in this instance, fit the Cotton Reel to help position
the block as shown in the example on page 3.
See example of the intended coverage below:
o
Unit
Tel: +44 (0)
420 89007 Fax: +44 (0)
1
All manuals and user guides at all-guides.com
•
MARKER
•
PUNCH
DESCRIPTION
MTG0018 CHAIN & SPROCKET GUARD
M0614 MOUNT BLOCK
M6x25MM CAP HEAD BOLT
M6x15MM COUNTERSUNK BOLTS
S1283 M6 COMPRESSION SLEEVE
S1284 M8 COMPRESSION SLEEVE
M10x19MM O/D WASHER
M10 ANTI-ROTATION WASHER
M6x25mm BUTTON HEAD BOLT
M8x25mm BUTTON HEAD BOLT
M10x25mm BUTTON HEAD BOLT
FITTING INSTRUCTIONS
WHICH IS MOST SUITABLE FOR YOUR BIKE.
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301 www.rg-racing.com Email: info@rg-racing.com
1
GENERAL TORQUE SETTINGS
M10 BOLT = 40Nm
M12 BOLT = 40Nm
LEGEND
R&G
M4 BOLT = 8Nm
M5 BOLT = 12Nm
M6 BOLT = 15Nm
M8 BOLT = 20Nm
TG0018
QTY
1
1
2
2
1
1
1
1
1
1
1
Publicité
