Télécharger Imprimer la page

Beko GNE 15906 S Mode D'emploi page 7

Froid ventilé
Masquer les pouces Voir aussi pour GNE 15906 S:

Publicité

Les langues disponibles

Les langues disponibles

2
Prior to operating your refrigerator
• Please remember that the manufacturer shall not be held liable if the
information given in the instruction manual is not observed. This product is
designed for domestic use.
Prior to operating your refrigerator, please read the instruction manual carefully that
includes important information such as installation, usage and maintenance of your
product.
Things to be done
• Your refrigerator should be installed at least 30 cm away from heat sources such as hobs,
ovens, central heater and stoves and at least 5 cm away from electrical ovens and should
not be located under direct sunlight.
• The ambient temperature of the room where you install your refrigerator should at least be
10°C. Operating your refrigerator under cooler conditions than this is not recommended with
regard to its efficiency.
• Please care to keep the inside of your refrigerator clean.
• If two refrigerators are to be installed side by side, there should be at least 2 cm distance
between them.
• Your refrigerator must run smoothly without any vibration. To ensure this, maintain the
balance of your refrigerator on the floor by turning the adjustable front legs clockwise or
counterclockwise. This should be done before the food is placed in the refrigerator.
• When you operate your refrigerator for the first time, please observe the following instructions
during the initial six hours.
- Temperature adjustment button should not be turned off.
- The door should not be opened frequently.
- It must be operated empty without any food in it.
- Do not unplug your refrigerator. If a power failure occurs out of your control, please see
the warnings in section "Things to be done before calling the authorized service".
• Original packaging and foam materials should be kept for future transportations or moving.
Points to be considered when transporting the product:
1.Your refrigerator must be emptied and cleaned prior to any transportation.
2. Shelves, accessories, crisper and etc. in your refrigerator must be fastened securely by
adhesive tape against any jolt before repackaging.
3. Packaging must be tied with thick tapes and strong ropes and the rules of transportation
printed on the package must be followed.
Please remember...
Every recycled material is an indispensable source for the nature and for our national
resources.
If you wish to contribute to recycling the packaging materials, you can get further information
from the environmental bodies or local authorities.
5
EN

Publicité

loading