Publicité
Les langues disponibles
Les langues disponibles
Operation (continued)
Vacuuming Liquids
1. When picking up small amounts of liq-
uid the filter may be left in place.
2. When picking up large amounts of liq-
uid we recommend that the filter be
removed. If the filter is not removed, it
will become saturated and misting may
appear in the exhaust.
3. After using the vac to pick up liquids,
the filter must be dried to avoid possible
mildew and damage to the filter.
4. When the liquid in the drum reaches a
predetermined level, the float mecha-
nism will rise automatically to cut off air-
flow. When this happens, turn off the
vac, unplug the power cord, and empty
the drum. You will know that the float
has risen because vac airflow ceases
and the motor noise will become higher
in pitch, due to increased motor speed.
WARNING: To reduce the risk of fire
or electric shock, do not run vac
unattended.
IMPORTANT: To avoid damage to the
vac do not run motor with float in raised
position.
All manuals and user guides at all-guides.com
Emptying the Drum
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
1. Remove the lid. Pull the flexible latches
2. While holding the latches out, lift the top
3. Lay top assembly upside down on a
4. Dump the drum contents into the proper
WARNING: To reduce the risk of
back injury or falls, do not lift a vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the vac light enough to lift
comfortably.
Moving the Vac
Should it become necessary to pick the
vac up to move it, DO NOT pick the vac up
by the lid handles unless dust drum is
empty. To avoid dropping the vac due to
latches releasing or possible part break-
age, pick the vac up by the lip of the dust
drum.
9
outward on each side of the lid to
release from the drum.
assembly up and away from the drum.
clean area while emptying drum or
changing filter.
waste disposal container.
Publicité
