RIDGID WD4550 Mode D'emploi page 12

SP6609 8/25/05 2:02 PM
Operation
Blowing Feature
Your wet/dry vac has the capability to be
used as a blower for yard work, patio
cleanup and workshop applications to
blow sawdust and other debris. Raise the
right cover and install the locking end of
the hose into the blower port.
Blowing
Port
Maintenance
Cleaning Vac Filter
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out of
your vac. Replace the filter immediately.
NOTE: The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used for
dry pick up or small amounts of liquid.
Handle the filter carefully when removing
to clean or installing it. Creases in the filter
pleats may occur from installation but will
not affect the performance of the filter.
Page 12
All manuals and user guides at all-guides.com
(continued)
Right
Cover
Locking
End of
Hose
12
WARNING: Always
goggles complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: Wear a dust mask if
blowing creates dust which might be
inhaled.
WARNING: To reduce the risk of
injury to bystanders, keep them clear
of blowing debris.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the vac/blower for
extended hours or when using it in a
noisy area.
Removal
To remove the filter for cleaning or
replacement, unscrew the filter nut from
the filter cage, remove filter plate and lift
off filter.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the vac for dry
material pickup.
CAUTION: Do not remove the filter
cage or float. It is there to shut off
airflow when the drum is full of
liquids.
wear safety