Toro Z Master HDX SD 2000 Serie Manuel De L'utilisateur page 49

9. Rotate the brake-linkage shaft until the end
aligns with the hole in the lever.
•
Shorten the linkage by turning it clockwise.
•
Lengthen the linkage by turning it
counterclockwise.
10. Insert the brake-linkage shaft into the
parking-brake hole and secure with the cotter
pin. Repeat step
11. When adjustment is complete, remove the jack
stands or equivalent support and lower the
machine.
12. Place the machine into the O
Refer to Using the Drive-Wheel Release Valves
(page 30).
5 and adjust if necessary.
position.
PERATING
Belt Maintenance
Inspecting the Belts
Service Interval: Every 50 hours
Replace the belt if it is worn. The signs of a worn belt
include squealing while the belt is rotating; the blades
slipping while cutting grass; and frayed edges, burn
marks, and cracks on the belt.
Replacing the Mower Belt
WARNING
The spring is under tension when installed
and can cause personal injury.
Be careful when removing the belt.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the mower to the 76 mm (3 inches) height
of cut.
4. Release the mower-deck curtain and remove
the sheet-metal guard; refer to
Mower-Deck Curtain (page 34)
the Sheet-Metal Guard (page
5. Completely loosen the bolts securing the belt
covers and remove the belt covers
6. Using a spring-removal tool (Toro Part No.
92-5771), remove the idler spring from the
deck hook to remove tension on the idler pulley
(Figure 61).
47
Releasing the
and Removing
34).
(Figure
Figure 60
60).
g027729