Christopeit Sport TM780 Notice De Montage Et D'utilisation page 19

Displays:
ENTFERNUNG/KCAL (DISTANCE/CAL) - Display:
Shows how far you have run in kilometers and the approx. consumed
kilocalories in kcal every 6 seconds.
ZEIT (TIME) - Display:
Shows how long you ran in minutes.
GESCHWINDIGKEIT (SPPED) - Display :
Shows the speed of the treadmill in kilometers per hour.
Key-Function:
[START]-Key:
Press this key to start exercise program (motor starts running).
[STOP]- Key:
Press this key during exercise to interrupt the program (motor stops
running). Within 5 min. you can press [START]-key again to conti-
nue this exercise program or press [STOP]-key again to finish this
program. Pre-values can set to zero by pressing the [STOP] - key.
[EINGABE] -Key (ENTER):
Select key of Time-program, Distance-program or Calories-program.
[PROG.]-Key (Programs):
Press this key to select exercising programs ((P1- P15.)
(HP1,HP2,HP3 OPTIONAL))
[+]-Key:
Press speed up -key increase settings or motor speed.
[-]-Key:
Press speed down -key decrease settings or motor speed.
Quick Speed -keys 4 and 8 km/h
User manual of Computer
Press one of these keys and the speed changes direct into 4 or 8
Manual
How to start manual mode:
Put in the AC plug in wall power (220V-240V, 50HZ-60HZ) and put
on the power switch. Put safety clip on to the computer and it will
show normal manual mode. Stand your feet on both side rails. Put
the safety key at you exercise cloth and press [START]-key to start
with exercising. After a 3 sec. count down, the motor begin to run
slowly and you can step on the running belt and follow the speed.
Adjust the speed with [+/-]- keys into desired speed. If put off the
safety clip from computer at any time, the motor stop slowly and the
display will show „---". After put on the safety key on computer the
normal manually program will show. Press [+/-] key to adjust value
of speed. Press quick speed key to adjust speed quickly. All values
of the displays will counter up.
Time-Program:
Press the [EINGABE]-key once and the time display lights up. [ZEIT/
PULS] -Display shows a suggestion of 30:00 minutes. Press [+/-]-key
to set value. The range is: 5:00-99:00min. If set a value the display
counts up till zero and then stops running motor.
Distance-Program:
Press the [EINGABE]-key until the distance lights up. [DISTANCE/
CAL] Display shows a suggestion of 1:00 km/h. Press [+/-]-key to
set value. The range is: 0,50- 99:90KM. If set a value the display
counts up till zero and then stops running motor.
Calories-Program:
Press the [EINGABE]-key until the KCAL lights up. [DISTANCE/
CAL] Display shows a suggestion of 50,0 kcal. Press [+/-]-key to set
value. The range is: 10-990 kcal. If set a value the display counts
up till zero and then stops running motor.
19